Universal R-320 Manual do Operador descarregar pdf (Página 18)

RUNNING THE L-15

Label stop position. Now that the machine is webbed,

turn on both the main and motor switches.

Slide the Web back and forth so the “label GAP” is lined up with the white dot on

the sensor.

Press the button on the sensor labeled “Normal”. The LEDS will start blinking

and then Stop.

The GREEN LED is power for the sensor.

If you slowly move the label back and forth the RED LED should come on while

the gap is in position. Moving the label so the GAP is out of position should make

the RED LED go out. The Setup is now complete.

Activating the Product Sensor makes the label advance. The speed at which it

advances is determined by the motor speed that is located on the control

enclosure. The Label Sensor stops the label by detecting the gap between the

labels.

Cycle the machine by activating the Product Sensor. The label should come off

the web so it is completely dispensed. However, the next label should stop

approx. 1/4” past the peeler tip. If label does not stop in proper place it can be

adjusted two ways. NOTE: The changing the speed of the applicator will

affect the label stop position.

1. Loosen the small ratchet handle at the Photo sensor. By moving it

towards the unwind assembly it will make the label stop sooner. By

moving it towards the peeler assembly, it will stop later (See Fig.16)

2. By adjusting the “OFF DELAY” on the front panel of the L-15. Turning

the knob clockwise will make the label stop later.

Fig.16

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 68 69

Sem comentários

Universal R-320 Manual do Operador Página 18