Universal R-320 Manual do Operador descarregar pdf (Página 14)

ADJUSTING PRODUCT SENSOR CONTINUED

2. After the Product Sensor is adjusted to the container, turn power to the

system on by pulling Red Emergency switch out, the Red light turns

OFF, turn Main switch ON. Turn Conveyor, Product Spacer and

Turning Unit switches to the OFF position, leaving the Applicator

switch in the ON position. Turn OFF motor switch on the label

applicator.

3. Place container under Fiber Optic Sensor. The sensor that the Fiber

Optic Cable is attached to needs to be set. It is located on the front of

the conveyor. On the sensor are a Yellow and a Blue button. Depress

either Yellow or Blue button for three seconds. Yellow button provides

Light “On” Output (Leading Edge). Blue button provides Dark “On”

Output (Trailing Edge).

NOTE: If required, use “Up” or “Down” to tweak adjustment. Turn

motor switch on the label applier back ON. (See Fig.11)

SETUP AND OPERATION CONTINUED

Yellow Button Blue Button

Fig.11

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 68 69

Sem comentários

Universal R-320 Manual do Operador Página 14